Logo Surisa

SURISA - Suministros Riol S.A.

Content

Castellano English

Main Page

Springs and Damping Units

Thermometers and thermal measurement

Guide Units

Cartridges and Heaters

Our Company

Ask Us

Our Web Page

Mailing List

Receive e-mails with information about our products

SUBSCRIBE        UNSUBSCRIBE

C/ Marina, 127
08013 - Barcelona
Tel. +34 93 231 08 11
Fax. +34 93 265 19 26
e-mail: surisa@surisa.es

Disclaimer
Privacy
Registered data


Helical Springs


Spring wire grade C Din 17223 . Available with different standard diameters and lengths. It is also possible to supply springs with lengths of 500 mm which can after be cut to the required size. Standard springs have flattned edges, prepared to be used. When it comes to the 500 mm springs, they are yet to be treated due to their purpose which is: Being cut by the user.

Springs with round cross section SZ-8100 and SZ-8101

Round cross section helical springs offer the best attributes because they have a lower tension when compared to the others.

The range SZ-8100 is available with exterior diameters of sizes between 10 to 84 mm and lengths from 24 to 200 mm, offering forces up to 6.620 N. Springs in the range SZ-8101 offer the same diameters and a length of 500 mm. Their purpose is to be cut according to the requirements.

  Standard tables measures :  
 
     

 

 

 

muelle SZ-8100
 

Springs with square cross section SZ-8200 and SZ-8201

Similar tolerance to Din 2095. Helical square cross section springs have greater tensions than the ones with round cross sections. Life span of this springs is slightly shorter due to a worse tension distribution along the spring.

Range SZ-8200 is available in exterior diameters of 10 to 70 mm and lengths of 20 to 120 mm, offering forces up to 5.010 N. Springs in the range SZ-8201 offer the same diameters and a length of 500 mm. Their purpose is to be cut according to the requirements.

  Standard tables measures :  
 
     

 

 

 

muelle SZ-8200
 

Springs with oval cross section SZ-8400 and SZ-8401

Helical oval cross section springs have greater tensions than the ones with round cross sections. Life span of this springs is slightly shorter due to a worse tension distribution along the spring.

Range SZ-8400 is available in exterior diameters of 11 to 50 mm and lengths of 20 to 230 mm, offering forces up to 3.440 N. Springs in the range SZ-8401 offer the same diameters and a length of 500 mm. Their purpose is to be cut according to the requirements.

  Standard tables measures :  
 
     

 

 

 

muelle SZ-8400
 
 
     

 

 

 


Home Page